Dynamic range

Overview

The term "dynamic range" is used to define the difference between the highest and lowest level and audio signal can have in a circuit or device. The lowest level is typically limited by noise in the system. At some point the signal level will be low enough for the signal to be obscured by the noise. At the other rend of the scale, the loudest signal level is typically defined by a certain level of distortion. Exactly what level of distortion is used varies with the application; and in the case of digital audio, corresponds to "full scale" or "digital clipping" level where all bits in the digital word are "1."

Basics

Dynamic range in audio is quite often referred to as the "signal-to-noise ratio" (SNR). It is typically specified in decibels (dB) which is a relative measurement- the ratio of the power of the signal to the power of the noise. The "signal" means the highest level signal the circuitry can handle without distortion and the "noise" is typically present in the circuitry whether or not the signal is present. The highest level the circuitry can handle is usually the point were a certain level of distortion is use to signify the onset of distortion. This means that the signal level will only need to be increase slightly for the distortion level to increase significantly.

The rate at which the distortion increases with level as well as factors such as what is considered to be acceptable distortion can vary with the type of device being measured. For example; in loudspeaker testing levels as high as 3-5 % distortion are not unusual compared to one-half a percent or less for high quality audio amplifiers. As a result; the distortion level used to determine the peak level is usually also specified as part of the SNR or dynamic range specification.